← NSN Search
RESISTOR,VARIABLE,WIRE WOUND,PRE
5905-00-901-5273NIIN 009015273InternationalEA · activeDEMIL ASOS SMSCatalog $666
FSC5905Resistors
Suppliers
5
DIBBS awards
0
Total value
—
Last award
—
Approved manufacturers
Qualified to supply per MCRL — no confirmed DIBBS award on record for this NSN. Each CAGE opens the manufacturer page.
18053SUBMINIATURE INSTRUMENTS CORP.OGDEN, UTSAM
PN 190-5-01
25413ES BETA, LLCRONKONKOMA, NYSAM
PN 2001091701
77272THE BOEING COMPANYRIDLEY PARK, PASAM
PN 114ES205-1, 114ES205-2
80294BOURNS INSTRUMENTS INCRIVERSIDE, CASAM
PN 20-0109-1701
98284ROSEMOUNT AEROSPACE, INC.SAN DIEGO, CASAM
PN RP67-0101-1
Characteristics
FLIS item characteristics from PUB LOG identification.
| Characteristic | Value |
|---|---|
| ACTUATOR TYPE | SINGLE SHAFT |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | SINGLE SECTION 40.0 |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER | SINGLE SECTION 160.0 |
| BODY HEIGHT | INCHES NOMINAL 0.750 |
| BODY LENGTH | INCHES NOMINAL 6.000 |
| BODY WIDTH | INCHES NOMINAL 1.000 |
| ELECTRICAL RESISTANCE PER SECTION | OHMS SINGLE SECTION 140.0 |
| FUNCTION CHARACTERISTIC PER SECTION | SINGLE SECTION LINEAR |
| FUNCTION CONFORMITY PER SECTION | SINGLE SECTION INDEPENDENT LINEARITY |
| FUNCTION CONFORMITY TOLERANCE PER SECTION | SINGLE SECTION -0.50 TO 0.50 |
| LONGITUDINAL ACTUATOR EFFECTIVE ELECTRICAL STROKE LENGTH | INCHES NOMINAL 1.320 |
| LONGITUDINAL ACTUATOR TRAVEL | INCHES MINIMUM 3.985 |
| MOUNTING FACILITY QUANTITY | 4 |
| MOUNTING METHOD | THREADED HOLE(S) |
| POWER DISSIPATION RATING PER SECTION IN WATTS | FREE AIR SINGLE SECTION 1.0 |
| RELIABILITY INDICATOR | NOT ESTABLISHED |
| RESISTANCE TOLERANCE PER SECTION IN PERCENT | SINGLE SECTION -1.0 TO 1.0 |
| SCREW THREAD DIAMETER | INCHES NOMINAL 0.112 |
| SCREW THREAD QUANTITY PER INCH | 40.0 |
| SCREW THREAD SERIES DESIGNATOR | UNIFIED NATIONAL COARSE (UNC) |
| SECTION QUANTITY | 1 |
| SHAFT DIAMETER | INCHES MAXIMUM 0.1875 |
| SHAFT LENGTH | INCHES NOMINAL 1.250 |
| SPECIAL FEATURES | 4 TAPPED HOLES TWO EA ON OPPOSITE SIDES SPACED 5.500 IN. C TO C |
| TERMINAL LOCATION | LOCATION NOT OTHERWISE SPECIFIED RIGHT-LEFT ADJACENT SIDES |
| TERMINAL TYPE AND QUANTITY | SCREW 6 |
| TEST DATA DOCUMENT | DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) 77272-114ES205-1 |
| THREAD LENGTH | INCHES NOMINAL 1.000 |